HP Virtual Connect Enterprise Manager Software - Manual (Page 73)

To add WWN custom address ranges:
1. From the Virtual Connect Enterprise Manager home page, under the Administration heading, click the
World Wide Names
hyperlink.
2. From the Select ranges to configure link, select WWN.
3. Click Add custom. The Add Custom WWN Address Range information appears.
4. Enter the custom WWN address range.
5. Click OK.
Editing custom WWN address ranges
Because the maximum range size is 131,072, a large range might take a few minutes to edit. You can
create one custom range.
1. From the VCEM home page, under the Administration heading, click the World Wide Names hyperlink.
2. From the Select ranges to configure link, select WWN.
3. Select a WWN address range.
4. Click Edit.
5. Edit the WWN address range as necessary. Valid WWN ranges cannot contain all 0s or all Fs and
cannot have an F within either of the first two octets.
6. Click OK.
Deleting custom WWN address ranges
NOTE: Removing a custom WWN address range also removes its defined exclusion ranges.
1. From the Select ranges to configure link, select WWN.
2. Select the custom WWN range.
3. Click Delete. You are prompted to confirm your choice.
4. Click OK.
WWN Addresses 73