HP LaserJet 6L Pro Printer - Manual (Page 36)

34 Chapter 3 - Printing EN
Tips for duplex printing
● To avoid paper curl, set the paper path lever to the lower position
and use the heavy media output slot for a straight-through paper
path.
● To print one page at a time, select the manual feed option in your
software to pause the printer between pages.
● Make certain that the sheet’s leading edge is not bent or curled.
Pausing the printer between pages
Occasionally, you may need the printer to pause so that you can load
special media, such as letterhead. If you specify manual feed in your
software, the printer will pause before printing the first page and
between each page you print. This will give you time to load the
special media.
1 In your software’s printer menu or bin/tray selection, select the
manual feed mode.
2 From your software, print the document. The Data light will blink
when the page is ready to print, indicating that the printer is
paused and waiting.
3 After inserting the correct medium, the printer will pick the sheet
automatically. The printer will take media from the single-sheet
input slot first. If it does not find media in the single-sheet input
slot, it will take media from the paper input bin.
Resetting the printer
Resetting the printer accomplishes the following:
● Clears all data from the printer memory (including unprinted data,
downloaded fonts, and macros).
● Finishes printing the current page.
● Removes some error conditions.
● Resets the printer to its factory default settings.
To reset the printer
Press and hold the control panel button until the three indicator lights
begin to blink in succession (about 5 seconds), and then let go of the
button. After resetting, the Ready light will remain lit if no printer
errors are found.