HP LaserJet 6L Pro Printer - Manual (Page 16)

14 Chapter 1 - Setup EN
Loading paper into the printer
Before loading paper into the printer,
raise the paper supports located behind
the paper input bin and the paper output
bin. Using paper supports can help
prevent unwanted paper curl and paper
jams.
1 Raise the supports on the paper
input bin and on the paper output bin
until they snap into place.
2 Insert up to 100 sheets of paper into
the paper input bin.
Note
Be careful not to overfill the bin.
3 Center the paper using the paper
guides on the paper input bin.
To test your printer, you can print a self-
test page. To do so, make sure the
Ready (bottom) light is on and all other
indicator lights are off. Press and release
the control panel button. (If the printer is
in SleepMode [all lights are off], you will
need to press the control panel button
twice.) The Data (middle) light will come
on and the Ready (bottom) light will
blink. The self-test page prints.
Note
When adding paper to an existing stack
in the paper input bin, always remove
and realign all paper to avoid multiple
paper feeds, paper jams, or both.
1
2
3