HP XP P9000 Command View Advanced Edition Software User Manual
Page 109
Related topics
• About the Add Command Devices Wizard
Storage system types and volume requirements (command devices)
Volumes that meet the requirements listed here are displayed as candidate volumes in Replication
Manager.
Storage system types and requirements for using volumes as command devices
XP24000/
XP20000/
HP P9500
HP XP7
XP12000/
XP10000/
SVS200
Requirement
Y
Y
Volume not a paired volume
Y
Y
Volume not an external volume
Y
Y
Volume not a virtual volume
Y
Y
Volume access attribute must be Read or Write
Y
Y
Volume not reserved for Auto LUN
Y
1
N
Not a virtual DKC
Legend:
Y: This requirement applies.
N: This requirement does not apply.
1.
This requirement is applied for HP XP7 only.
Command device settings for virtual machines
The Replication Manager command device configuration function cannot be used to set a volume as
a command device if the volume has been allocated for a VMware virtual machine.
To set a command device for the virtual machine:
1.
Use XP7 Remote Web Console to set the volume as a command device.
2.
Use XP7 Remote Web Console to add the command device in (1) to a VMware host group and
set a path for the command device.
3.
Perform VMware Raw Device Mapping, and then make sure that the command device in (1) is
recognized by the virtual machine.
User Guide
109