HP NonStop G-Series - Manual (Page 92)

Access State Indicates whether the primary disk path is active or inactive.
Backup Path
FSAC
Identifies the backup FCSA that manages the disk.
Example: FCSA FSAC (111.3.2.1)
Configured FSAC
Location
Displays the configured location of the FCSA FSAC containing the backup
disk path controller. This attribute is displayed even if the physical FCSA
FSAC is not present.
Example: FCSA.SAC-1.GRP-111.MOD-3.SLOT-2
Access State Indicates whether the backup disk path is active or inactive.
Firmware
Version The version of the firmware running on the disk.
OEM Product ID The firmware product ID assigned by the supplier.
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of the all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Primary Path action before you can start the path again.
Blink LED Off
Turns off the blinking of the disk drives (amber) fault LED.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y}, BLINK NONE
Blink LED On
Causes the disk drives (amber) fault LED to blink on and off.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y}, BLINK ALL