HP NonStop G-Series - Manual (Page 113)

Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Physical
Part Number
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
LED State
Indicates whether or not the FC-AL I/O Modules (amber) fault LED is
blinking.
Value: Blinking or Off
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Type The vendor hardware type.
Logical
Vendor Hardware Revision
A code that identifies the generation of the component provided by its
supplier.
Device State
The state of the component as known to the operating system on the
server.
Values
Device Connection
Fibre Channel
Controller
The number that identifies the FCSA FSAC connected to the FC-AL I/O
Module.
Example: FCSA FSAC (111.2.1.1)
Configured
Controller Location
The location of the configured FCSA connected to the FC-AL I/O Module.
Example: FCSA.FSAC-1.GRP-111.MOD-2.SLOT-1
Actions
Blink LED Off
Turns off the blinking of the FC-AL I/O Modules (amber) fault LED.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y}, BLINK NONE
Blink LED On
Causes the FC-AL I/O Modules (amber) fault LED to blink on and off.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y}, BLINK ALL
Replace