HP NonStop G-Series - Manual (Page 200)

Duration of Suppression
How long the suppression will last (in minutes). The
default value is 40 minutes. You can extend he time using
the
Extend Problem Incident Report Suppression Time
action.
This attribute is shown only if the Problem Incident Report
Creation State value is Suppressed.
Actions
Add Node to ServerNet Cluster
Launches a guided procedure that adds the local system to a ServerNet Cluster. This procedure is
also used to configure or display information for Expand-over-ServerNet line handlers.
Collect Diagnostic Data
Initiates manual collection of data for a specified system resource. Upon performing the action, you
are prompted to specify the subsystem resource, along with date and time parameters. Supported
resources include PMF, IOMF, SEB/MSEB, Battery, Fan, Power, Disk, Tape, SNDA, FXSA, and
SWAN.
The volume in which this diagnostic data is collected is specified by the Set Data Collection Volume
action.
Detect New Hardware
This action is used during service procedures to detect any new slice or LSU component that had
been disabled or isolated from the system by user.
Note: Generally, new hardware is detected dynamically once it is cabled. This action is only
required for recognizing components connected on a port that had been disabled.
Disable Advanced Storage Configuration
Disables the system's Advanced Storage Configuration State attribute. In the disabled state, no
advanced storage configuration changes, such as Flexible Disk Configuration or configuration of
ESS disks, can be made on the system.
Enable Advanced Storage Configuration
This action changes the system's Advanced Storage Configuration State attribute to Enabled. This
state must be enabled before you can configure ESS disks in SCF or perform Flexible Disk
Configuration.
Enable/Disable Automatic Data Collection
Use to enable or disable automatic collection of data for failed system resources. The current state for