Firmware, Update, Configuration update – HP NonStop G-Series User Manual
Page 240: Actions on the servernet ii switch component, Replace, Procedure has been replaced by separate, Firmware update, Actions of the servernet ii switch
Causes the LED to blink on and off.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y}, BLINK ALL
Configuration Update
This action updates the configuration for the ServerNet II switch component of the 6770 switch
module. For more information, see
Note: If you are updating both firmware and configuration on the same cluster switch, you
should always update the firmware first. In some circumstances, updating both
firmware and configuration is not necessary. For more information, see the
ServerNet Cluster Manual.
Optional Parameter: File name of the configuration file.
Firmware Update
Updates the firmware on the ServerNet II switch component of the 6770 switch module. For
more information, see
Optional Parameter: File name of the firmware file.
Hard Reset
Is necessary following a Configuration Update action in order for the changes to take effect.
Caution: This action disrupts the ServerNet traffic through this switch.
SCF Equivalent: SCF RESET SWITCH $ZZSMN, NEAREST { X | Y }, HARD
Prepare to Replace
Must be performed from each node of a ServerNet cluster before replacing a ServerNet II
Switch for SANMAN to accept the new switch.
Replace
Launches the guided procedure for replacing a ServerNet II Switch.
Set Fabric Setting
Sets the fabric LED indicator for the ServerNet II Switch to either X or Y.
Within three minutes after the action completes, the SANMAN process running on each of the
nodes discovers that the fabric setting has been corrected and accepts the new switch.
Parameter: Fabric Setting can be set to Unknown, Clear, X,or Y.