HP NonStop G-Series User Manual
Page 124
External Loopback Test
Performs the external loopback firmware diagnostic test.
Before running this test, you must use the Stop action to put the ServerNet/FX or ServerNet/FX 2
adapter field-replaceable unit (FRU) in the Stopped state.
Firmware Update
Updates the firmware for a ServerNet/FX adapter (FXSA) or ServerNet/FX 2 adapter (FX2SA).
Responsive Test
Verifies that the component is installed and responding.
Set FOX Cluster Number
Sets the node to which the ServerNet/FX or ServerNet/FX2 adapter FRU is connected.
Set Left Transmitter Power Level
Sets the fiber-optic transmitter LED power for the right direction on the FOX ring.
High LED power is suitable for distances of 2 km through 4 km.
Low LED power is suitable for distances of less than 2 km.
Before setting the LED power level, you must use the Stop action to put the ServerNet/FX or
ServerNet/FX 2 adapter FRU in the Stopped state. The current power level is indicated by the
Set Right Transmitter Power Level
Sets the fiber-optic transmitter LED power for the right direction on the FOX ring.
High LED power is suitable for distances of 2 km through 4 km.
Low LED power is suitable for distances of less than 2 km.
Before setting the LED power level, you must use the Stop action to put the ServerNet/FX or
ServerNet/FX 2 adapter FRU in the Stopped state. The current power level is indicated by the
Start
Starts the ServerNet/FX or ServerNet/FX 2 adapter field-replaceable unit (FRU) that is in the
Stopped state. During startup, the controller operational code is automatically loaded into the FRU.
When the Start action completes, the FRU is in the Started state.
Stop