HP NonStop G-Series - Manual (Page 228)

Numeric Selector Setting Used
by Firmware
The 4-digit numeric selector setting that is currently used by
the firmware.
Example: 9621
Temperature
Current Value
The current temperature, in degrees Celsius (°C), inside the
enclosure of the module.
Normal Maximum Value
The maximum acceptable air intake temperature is 65 degrees
Celsius. If the temperature rises above 65 degrees, an alarm is
generated.
Actions
Blink All LEDs Off
Turns off the blinking of the fault LEDs on the switch logic board, PICs, power supplies and
fans.
SCF Equivalent: ALTER SWITCH, BLINK NONE
Blink All LEDs On
Causes the fault LEDs on the switch logic board, PICs, power supplies, and fans to blink on and
off.
SCF Equivalent: ALTER SWITCH, BLINK ALL
Connect to UPS
Starts a new Internet Explorer window and loads the default HTTP home page provided by the
UPS vendor.
Parameter: IP Address (the IP address of the UPS)
Replace
Invokes the Replace Switch Component guided procedure that helps to replace the switch
module.
Responsive Test
Tests the connectivity of the switch module from the local node.
Set Locator