Chapter 3. configuring osm, Configuring osm, Configuring the server – HP NonStop G-Series User Manual
Page 28: Next
Chapter 3. Configuring OSM
Chapter 3. Configuring OSM
Configuring Service Provider Access
Before using OSM applications to manage your system:
Configure the server using the OSM Low-Level Link.
●
Configure service provider access using the OSM Notification Director.
●
Configure the OSM Notification Director during OSM installation to run as a Windows
Service, which allows it to run without requiring a Windows logon. For more
information, see
●
Note: It is possible to start and run a new server without performing OSM configuration.
However, HP strongly recommends that you perform OSM configuration tasks
shortly after installing a new system. If you do not perform OSM configuration, your
system will have certain user, security, and network limitations.
For complete configuration procedures, see:
NonStop NS-Series Hardware Installation Manual
●
OSM Low-Level Link online help
●
OSM Notification Director online help
●
Configuring the Server
You must configure these server components using the OSM Low-Level Link:
Use this dialog box
To
Network
Configure unique MSP IP addresses for your primary and backup LANs.
Startup Windows
Define the workstations authorized to display the startup TACL prompt
and receive the event messages that occur during a system load.