HP Integrity NonStop H-Series - Manual (Page 70)

Troubleshooting
5158ACL Tape Drive Installation and User’s Guide — 524955-002
A- 2
Recovering from Errors
Recovering from Errors
Fault Symptom Codes are listed in Table A-2 . Error Recovery Procedures (ERP)
are described in detail in Table A-1 . ERP are listed for each FSC.
Error Recovery Procedures
Table A-1 gives error recovery instructions for errors reported on the front panel.
This list includes only those procedures that can safely perform by an operator.
The Service Manual includes additional procedures that can perform by an
experienced service technician.
Fault Symptom Codes (FSC)
Fault Symptom Codes appear in the Fault screen shown in Figure A-1 . Each
FSC is accompanied by a descriptive message and instructions for clearing the
fault. If a fault persists, look up the FSC in
Table A-2 and call a service provider.
To help identify the problem be sure to provide the FCS.
Table A-1. Error Recovery Procedures
ERP Number Procedure Detail
C Cycle power to the drive using the AC switch on the
front panel of the tape drive. Wait 30 seconds to
power on again.
D Turn off power to the tape drive and inspect
connectors and cables.
F Invalid operation. Select parameters correctly and try
again.
G Call a service provider.
Table A-2. Fault Symptom Codes
FSC Displayed Message ERP
2072 Drive Power up error C¬ G
3001 Picker Tries Excd C¬
D¬ G
3002
Power Down to
Clear
Picker Tach
Errors
D¬ G
3003 Elevator Tach Errors D¬ G