HP Integrity NonStop H-Series User Manual
Page 63
Configuring the Tape Drive for the NonStop S-Series
Server
5158ACL Tape Drive Installation and User’s Guide — 524955-002
4 -3
PMF CRU
To add the tape drive:
-> SCF
-> ADD TAPE $ACLTAP, SENDTO STORAGE, LOCATION (1,1,50),
DEVICEID 5, PRIMARYCPU 0, BACKUPCPU 1
-> START TAPE $ACLTAP
-> INFO TAPE $ACLTAP, DETAIL
In this example:
•
The LOCATION attribute specifies the location (group, module, and slot) of
the PMF CRU (adapter) to which the tape drive is attached.
•
The DEVICEID attribute shows the device ID that is configured for the
device. This ID must match the SCSI ID that is physically set in the device.
•
The PRIMARYCPU attribute specifies the processor in which the primary
tape process should execute.
•
The BACKUPCPU attribute specifies the processor in which the tape
process starts its backup process.
For more information on the ADD and INFO commands, see the SCF Reference
Manual for the Storage Subsystem.