HP Integrity NonStop H-Series - Manual (Page 49)

Operating the Tape Drive
5158ACL Tape Drive Installation and User’s Guide — 524955-002
3- 15
Map Information Screen
Map Information Screen
When you select Map Info, a screen similar to Figure 3-13 appears. The location
of the element being reported appears on line 1.
Lines 1, 2, 3, and 4 on this screen are scrollable in unison. For each scroll
position, line 1 displays one of the following locations:
•
DLT1
•
slot 1 through slot 10
If the server software license permits fewer slots than the tape magazine
contains and if reserved slots have been designated in accordance with that
license or to use the Autoclean mode, fewer slots are displayed. For the
procedure on designating reserved slots see
Section 2, Installing and
Configuring the Tape Drive .
Depending on the presence or absence of a tape cartridge in the element being
reported, line 2 displays either “Empty” or “Occupied.”
Depending on the report for each location, line 3 displays either “Label Valid” or
“Label Not Present.”
For each location reported, line 4 displays the actual bar code on the label, with
up to 8 characters. If there is no label or if no bar code reader is installed, line 4
is blank.
Maintenance
The Maintenance menu and the options intended for operator use are described
in
Section 5, Maintaining the Tape Drive . Additional options on the Maintenance
menu that are intended for use by a service provider are described in the
Service Manual.
Configure
For information about the Configure menu, see Section 2, Installing and
Configuring the Tape Drive .
Figure 3-13. Map Information Menu