HP Integrity NonStop H-Series - Manual (Page 28)

Installing and Configuring the Tape Drive
5158ACL Tape Drive Installation and User’s Guide — 524955-002
2 -8
Connect the Power Cord
Connect the Power Cord
1. Check that the power switch on the tape drive is set to 0 (off).
2. Connect the power cord to the power connector on the tape drive. Check
that the power cord is fully seated.
3. Connect the other end of the power cord to a nearby AC outlet.
Setting Up Reserved Slots
You can use one of the reserved slots for a cleaning cartridge to use the
Autoclean function. However, you can use this function only while the tape drive
is operating in Random Library mode in conjunction with NonStop server
software, such as Auto Cartridge Loader Media Manager (ACLMM).
1. Navigate from the Default screen through the Main menu to the Configure
menu. See Figure 2-3 through Figure 2-5 .
2. Scroll down the Configure menu to Set Reserved slots, and select that
option. The screen shown in Figure 2-11 appears.
3. With the cursor next to line 1, press Enter. The cursor moves to line 2, a
down arrow appears at the end of line 4, and an up arrow appears at the end
of line 1.
4. On line 2, scroll to specify the number of slots to be reserved. Scroll to the
desired number, and press Enter.
5. Press Escape repeatedly to return to the Default screen.
Note. The tape drive does not have protection against lighting surges. Customers located in
high risk areas should use external surge protection rated for use in their location and able to
handle the power demand of the tape drive.
Figure 2-11. Set Reserved Slots Menu