Restrictions and limitations, Command line syntax – HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem User Manual
Page 6
Introduction 6
Restrictions and limitations
•
A VCSU update operation can be performed from a server blade in the same enclosure that is being
updated. However, this feature is supported only when using a redundant network configuration on the
server blade running the VCSU client.
•
This version of VCSU supports c3000 and c7000 enclosures.
•
The utility does not update modules that are powered off, non-functional, or not physically present. A
status message indicates whether any modules are in these states.
•
The utility does not update unknown or unsupported module types, including pass-thru Ethernet and FC
modules.
•
HTTP and HTTPS downloads are restricted to non-authenticated websites.
•
FTP downloads are restricted to non-SSL/TLS, Passive Transfer Mode FTP sites.
•
IP addresses that are not accessible time out within 20 seconds. IP addresses that have an active
SSL-enabled web server, but not an OA, fail immediately.
•
Only IPv4 addresses are supported in this release.
•
Prior to running VCSU, ensure that the maximum supported number of local user accounts for the
Onboard Administrator has not been reached. For multi-enclosure domains, verify this information for
each enclosure in the domain.
•
VCSU does not use any root certificates to connect to OA and VC.
Supported modules
Module
Supported in
VCSU 1.8.1
HP 1/10Gb Virtual Connect Ethernet Module
Yes*
HP 1/10Gb-F Virtual Connect Ethernet Module
Yes*
HP Virtual Connect Flex-10 10Gb Ethernet Module
Yes
HP Virtual Connect FlexFabric 10Gb/24-port Module
Yes
HP Virtual Connect Flex-10/10D Module
Yes
HP 4Gb Virtual Connect Fibre Channel Module
Yes
HP Virtual Connect 4Gb Fibre Channel Module
Yes
HP Virtual Connect 8Gb 24-Port Fibre Channel Module Yes
HP Virtual Connect 8Gb 20-Port Fibre Channel Module Yes
* Supported only for updates to VC version 3.60 or lower. This module is not supported for updates to VC version 3.70
or higher.
Command line syntax
CLI input is case-insensitive except when otherwise noted. The general CLI syntax is as follows:
vcsu -a
Parameters are extensions that provide extra information required for the execution of a particular command.
Whether or not a parameter is required depends on the specific action being executed.
For example, the version command includes parameters for IP address, username, and password. The
syntax is as follows:
- Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem 4GB Virtual Connect Fibre Channel Module for c-Class BladeSystem Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem Virtual Connect Flex-10.10D Module for c-Class BladeSystem Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem