AIS Router AI2524 - Manual (Page 258)

AI2524 Router Card User’s Manual
Page 11-32 August 1997
2524UM
Enable PPP on
VTY Lines for
Asynchronous
Access over ISDN You can configure a router to support asynchronous access over ISDN
by globally enabling PPP on VTY lines. PPP is typically enabled on
synchronous or asynchronous serial interfaces; however, the Cisco
IOS software permits you to configure PPP on VTY lines. This con-
figures the VTY line to support asynchronous access over ISDN from
an ISDN terminal to a VTY session on the router.
In global configuration mode, enable asynchronous protocol features
on all the router's VTY lines:
vty-async
This task enables PPP on VTY lines on a global basis on the router. To
configure PPP on a per-VTY basis, use th
translate command.
Monitor and
Maintain MLP,
MMP, and VPDN
Virtual Interfaces
To monitor and maintain virtual interfaces, you can perform any of
these tasks:
z Display MLP and MMP bundle information.
show ppp multilink
z Display information about the active L2F tunnels and the L2F
message identifiers.
show vpdn
z Display the status of the stack group members.
show sgbp
z Display the current seed bid value.
show sgbp queries