AIS Router AI2524 User Manual
Page 193
Chapter 9: AI2524 OSI/CLNP Configuration Steps
August 1997
Page 9-35
2524UM
3.
Pass ISO CLNS traffic on ethernet 0 to end systems without rout-
ing:
interface ethernet 0
clns enable
4.
Pass ISO CLNS traffic on serial 0 to end systems without routing:
interface serial 0
clns enable
5.
Create a static route for the interface:
clns route 47.0004.004d.0099 serial 0
clns route 47.0005 serial 0
Example 2
This is a more complete example of CLNS static routing on a system
with two Ethernet interfaces. After configuring routing, you define
NET and enable CLNS on the Ethernet 0 and Ethernet 1 interfaces.
You must then define an ES neighbor and define a static route with the
clns route
global configuration command, as shown. In this situ-
ation, there is an ES on Ethernet 1 that does not support ES-IS.
illustrates this network.
Figure 9-9:Static Routing