Chapter 10: serial interface configuration steps, Introduction, Configure the synchronous serial interfaces – AIS Router AI2524 User Manual

Page 225: Serial interface configuration steps

background image

Chapter 10: Serial Interface Configuration Steps

August 1997

Page 10-1

2524UM

Chapter 10: Serial Interface

Configuration Steps

Introduction

This chapter describes how to configure synchronous serial interfaces.

Configure the
Synchronous
Serial Interfaces

The synchronous serial interfaces are configured to allow connection
to WANs. Once the Ethernet or Token Ting port on your router has
been configured, complete these steps to configure the synchronous
serial interfaces:

1.

Press or type yes to configure serial port 0:

Configuring interface Serial0:

Is this interface in use? [yes]:

2.

Determine which protocols you want on the synchronous serial
interface and enter the appropriate responses:

Configure IP on this interface? [yes]:

Configure IP unnumbered on this interface? [no]:

IP address for this interface: 172.16.73.1

Number of bits in subnet field [8]:

Class B network is 172.16.0.0, 8 subnet bits; mask is

255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [yes]:

AppleTalk starting cable range [2]: 4

AppleTalk ending cable range [3]: 4

AppleTalk zone name [myzone]: ZZ Serial

AppleTalk additional zone name:

Configure IPX on this interface? [no]: yes

IPX network number [2]: B002