AIS Router AI2524 - Manual (Page 185)

Chapter 9: AI2524 OSI/CLNP Configuration Steps
August 1997 Page 9-27
2524UM
IS-IS
To run IS-IS instead of ISO IGRP, use this configuration. The illustra-
tion in
Figure 9- still applies. Ethernet interface 2 is configured for
IS-IS routing and is assigned the tag of test-proc2.
router iso-igrp test-proc1
net 49.0002.0002.bbbb.bbbb.bbbb.00
router isis test-proc2
net 49.0001.0002.aaaa.aaaa.aaaa.00
!
interface ethernet 1
clns router iso-igrp test-proc1
!
interface serial 2
clns router iso-igrp test-proc1
!
interface ethernet 2
clns router IS-IS test-proc2
To allow CLNS packets only to blindly pass through an interface with-
out routing updates, you could use a simple configuration. This exam-
ple shows such a configuration:
clns routing
interface serial 2
This permits serial 2 to pass CLNS packets without having CLNS rout-
ing turned on:
clns enable
Configure IS-IS Parameters
Cisco's IS-IS implementation allows you to customize certain IS-IS
parameters. You can perform the optional tasks:
z Specify Router-Level S upport
z Configure IS-IS Authentication Passwords
z Ignore IS-IS Link-State Packet (LSP) Errors
z Log Adjacency State Changes
z Change IS-IS LSP MTU Size