Canon imagePROGRAF iPF815 MFP M40 - Manual (Page 49)

49
Error Messages
Error Message Cause Corrective Action
The roll feed unit is loose. The Roll Unit is detached from the
printer.
Push the Roll Unit firmly all the way in.
Roll x is empty. (x is 1 (Upper) or
2 (Lower)) Press OK. The roll is empty. Follow these steps to replace the used roll with a new
roll of the same type and size.
Press the OK button and remove the roll. 1.
Load the new roll. 2.
If no barcode was printed on the roll, specify the
type of paper. 3.
If no barcode was printed on the roll, specify the
paper length. 4.
(→ , Removing the Roll from the Printer)
(→"Removing the Roll Holder from Rolls," User
Manual)
(→ , Attaching the Roll Holder to Rolls)
(→ , Loading Rolls in the Printer)
(→"Specifying the Paper Length (Roll)," User
Manual)
(→"Selecting the Paper Type (Roll)," User Manual)
Roll feed unit error. There is a problem with the Roll
Unit . Turn off the printer and wait at least three seconds
before restoring the power. If the message is
displayed again, contact your Canon dealer for
assistance.
If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button. 5.
Printing will resume, starting from the page on
which the error occurred.
No Roll Unit. The printer has received a print job
that specifies Roll 2 (Lower) , but
the Roll Unit is not installed. Hold down the Stop button for a second or more to
cancel printing.
Turn the printer off and install the Roll Unit .
Connect the Roll Unit Cable firmly and completely.
Turn the printer on and resend the print job. 1.
2.