Canon imagePROGRAF iPF815 MFP M40 - Manual (Page 46)

46
Error Messages
Paper size not detected. Paper has been loaded askew, or
warped paper has been loaded. Follow these steps to reload the roll.
Lift the Release Lever . 1.
Open the Top Cover . 2.
Adjust the right edge of the roll to make it parallel to
the right Paper Alignment Line . 3.
Lower the Release Lever . 4.
Close the Top Cover . 5.
Error Message Cause Corrective Action
If this error recurs after you reload the roll, remove
the Roll Holder from the printer, push the roll firmly in
until it touches the Roll Holder flange, and reload the
Roll Holder in the printer.
Follow these step to reload a sheet.
Lift the Release Lever . 1.
Open the Top Cover . 2.
Adjust the right edge of the sheet to make it parallel
to the right Paper Alignment Line and the trailing
edge of the sheet to make it parallel to the paper
alignment line under the Paper Retainer . 3.
Lower the Release Lever . 4.
Close the Top Cover . 5.
Papr Type Mismatch You tried to print a test pattern
for printer adjustment on several
sheets, but sheets of different
types of paper were used. Hold down the Stop button for a second or more to
cancel printing.
When printing a test pattern, use sheets of the same
type of paper.
Lift the Release Lever and load a sheet of the same
type of paper.
(→ , Loading Rolls in the Printer)
(→ , Attaching the Roll Holder to Rolls)
(→ , Loading Sheets in the Printer)
(→"Loading and Printing on Sheets," User Manual)
If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button. 6.
Printing will resume, starting from the page on
which the error occurred.
If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button. 6.
Printing will resume, starting from the page on
which the error occurred.