Canon XEED WUX450 - Manual (Page 111)

111
Customizing System Operation (System Settings)
Oper
ation
Setti
ng Fu
nctio
n
s fr
om Me
nus
Specifying Direct
Power-On
> [System settings] > [Direct power
on]
You can turn on the projector by
connecting the power cable without
pressing the POWER button.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• [Off] is the factory default.
Specifying Silence or
Operating Tones
> [System settings] > [Beep]
You can select whether a beep
sounds or not when you operate the
projector.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• The factory default is [On].
• The beep will not sound if you mute the
projector sound with the MUTE button on
the remote control.
HDMI Component LAN
Digital PC Analog PC USB
Off You need to press the POWER button
to turn on the projector.
On You can turn on the projector by
connecting the power cable only.
• Before enabling direct power on, be
sure to set [Auto power-off] to an
option other than [Disabled].
Selecting [Disabled] will prevent you
from using auto power-off.
• After turning off the projector, wait at
least 5 minutes before turning it on
again. It may shorten the lamp life if
you turn on the projector
immediately after turning it off.
HDMI Component LAN
Digital PC Analog PC USB
Off Disables the beep.
On Enables the beep.