Brother NC-2100p - Manual (Page 89)

APPENDIX
APPENDIX-1
A
APPENDIX
Appendix A
General Information
You can change the configuration of your print server using any of the following
methods.
• Brother BRAdmin Professional utility for Windows 95 or later
• HTTP (using a web browser)
• HP’s JetAdmin or WebJetAdmin Software
• TELNET (command utility)
BRAdmin Professional utility (Recommended)
The Brother BRAdmin Professional utility can use the TCP/IP protocol. This utility
allows you to graphically manage aspects of the network and printer. It can also be
used to upgrade the firmware of the print server.
HTTP (Recommended)
Use your favorite web browser to connect to the Brother print server. This will allow
you to configure print server parameters.
JetAdmin or WebJetAdmin
Brother’s print server range is HP JetAdmin and WebJetAdmin compatible.
TELNET
To connect to the print server using TELNET on UNIX, Windows NT, or most other
TCP/IP systems, type: TELNET ipaddress at the command prompt of the system
prompt, where ipaddress is the IP address of the print server. When you are
connected, push RETURN or ENTER to get the "#" prompt, enter the password
"access" (the password will not appear on the screen), and type anything in response
to the Enter Username> prompt. When you see the Local> prompt, you are ready to
enter commands.
Enter HELP at the command prompt for a list of supported commands.