Brother NC-2100p - Manual (Page 37)

CHAPTER 3 TCP/IP PEER TO PEER PRINTING
3-3
Associating to the printer
You must now create a printer on your Windows system using the standard
Windows printer setup procedure.
1. To do this, go the Start button, select Setting and then Printers.
2. Select Add Printer to begin the printer installation.
3. Click Next when you get the add Printer Wizard window.
4. Select Local Printer when you are asked how the printers are connected to
your computer, and then push Next.
5. Select the correct driver. Click Next when you are done.
6. If you have selected a printer driver that is already being used, you have the
option of either keeping the existing driver (recommended) or replacing it.
Select the desired option and press Next.
7. Select the Brother LPR port (port name you assigned in step 4 of the
Installing the Brother Peer to Peer Print (LPR) Software section) and press
Next.
8. Enter any desired name for the Brother printer and press Next. For example,
you could call the printer "Networked Brother Printer".
9. Windows will now ask you if you wish to print out a test page, select Yes
and then select Finish.
You have now finished installing the Brother Network Direct Print software.
Adding a Second Brother LPR Port
You do not re-run the install program to add a new Brother LPR port. Instead, press
the Start button, select Settings, and open the Printers windows. Click on the icon of
the printer that you wish to configure, select File form the Menu bar, and then
choose Properties. Click on the Details tab and push the Add Port button. In the Add
Port dialog, select the Other radio button and then highlight "Brother LPR port".
Click OK and enter the port name. The default port name is BLP1. If you have
already used this name, you will get an error message if you try to use it again, in
which case use BLP2, etc… Once you have specified the Port name, click the OK
button. You will then see the Port Properties Dialog.
Enter the IP address of the printer that you wish to print to and click OK. You should
now see the port that you have just created in the "Print to the following port" setting
of the printer driver.