beautypg.com

Using arp to configure the print server ip address – Brother NC-2100p User Manual

Page 71

background image

CHAPTER 8 TCP/IP CONFIGURATION

8-4

Using ARP to Configure the Print Server
IP Address


If you are unable to use the BRAdmin Professional utility and your network does not
use a DHCP server, you can also use the ARP command. ARP is the simplest
method of configuring the print server IP address. The ARP command is available on
Windows systems that have TCP/IP installed as well as Unix systems. To use arp
enter the following command the command prompt:

arp -s ipaddress ethernetaddress


Where ethernetaddress is the Ethernet address (MAC address) of the print server and
ipaddress is the IP address of the print server. For example:

Windows Systems

Windows Systems require the colon ":" character in-between each digit of the
Ethernet address.

arp -s 192.189.207.2 00:40:17:31:01:07


Unix Systems

Typically, Unix systems require the hash "-" character in-between each digit of the
Ethernet address.

arp -s 192.189.207.2 00-40-17-31-01-07


You must be on the same Ethernet segment (that is, there cannot be a router between
the print server and operating system) to use the arp -s command.
If there is a router, you may use BOOTP or other methods described in this chapter
to enter the IP address.
If your Administrator has configured the system to deliver IP adresses using BOOTP,
DHCP or RARP your Brother Print Server can receive an IP address from any one of
these IP address allocation systems, in which case, you will not need to use the ARP
command. The ARP command only works once. For security reasons, once you have
successfully configured the IP address of a Brother Print Server using the ARP
command, you can not use the ARP command again to change the address. The print
server will ignore any attempts to do this. If you wish to change the IP address again,
use a Web Browser, TELNET (using the SET IP ADDRESS command) or factory
reset the print server (which will then allow you to use the ARP command again).

To configure the print server and to verify the connection, enter the following
command ping ipaddress where the ipaddress is the IP address of the print server.
For example, ping 192.189.207.2.