Brother NC-2100p - Manual (Page 63)

CHAPTER 6 APPLETALK (ETHERTALK) TCP/IP PRINTING
6-8
How to Select the Print Server (TCP/IP)
After installing the PPD, use the following steps to select the printer driver:
1. Turn the power of the printer ON.
2. Open the Applications folder.
3. Open the Utilities folder.
4. Open the Print Center icon.
5. Click the Add Printer icon.
6. Select LPR Printers using IP.
7. Enter the TCP/IP address of the printer into the LPR Printer’s Address box.
For AppleTalk connections, the printer’s AppleTalk service name is
BRO_xxxxxx_P1_AT, where xxxxxx is the last six digits of the Ethernet address.
Printing the configuration page will allow you to confirm the TCP/IP address. To
print that details all network settings is to print a configuration page, use a fine ball
point pen to hold down the Test button on the back of the print server for less than 5
seconds.
Refer to Appendix of this user guide how to print the configuration page.
8. When specifying the “Queue”, use the value BRO_xxxxxx_P1_AT where
xxxxxx are the last six digits of the Ethernet address.
9. From the Printer Model pull-down list select your model.
10. Click Add and the printer will be available from the Printer List