Brother NC-2100p - Manual (Page 70)

CHAPTER 8 TCP/IP CONFIGURATION
8-3
Some of the printer might unable to print the configuration page. In that case, check
the printer configuration by BRAdmin Professional utility or Web Based
Management.
Refer to Appendix of this user guide how to print the configuration page.
5. Input the IP address, Subnet mask and Gateway (If needed) of your print
server.
6. Click OK then select Close.
7. With the correctly programmed IP address, you will see the Brother print
server in the device list.
Using DHCP to Configure the IP address
Dynamic Host Configuration Protocol (DHCP) is one of several automated
mechanisms for IP address allocation. If you have DHCP Server in your network
(typically a Unix, Windows NT/2000) the print server will automatically obtains its
IP address from DHCP server and register its name with any RFC 1001 and 1002-
compliant dynamic name services.
If you do not want your print server configured via DHCP, BOOTP or RARP, you
must set the BOOT METHOD to static, this will prevent the print server from trying
to obtain an IP address from any of these systems. To change the BOOT METHOD,
use the TELNET (using the SET IP METHOD command), Web browser or by using
the BRAdmin Professional utility.