Guidelines for printing on both sides of the paper – Brother HL-6050DN User Manual
Page 48
ABOUT THIS PRINTER 1 - 40
Guidelines for printing on both sides of the paper
■
If the paper is thin, it may wrinkle.
■
If paper is curled, straighten it and then put it back in the paper tray.
■
You should use regular paper. Do not use bond paper.
■
If the paper is not feeding properly, it may be curled. Remove the paper and straighten it.
■
(For manual duplex printing) When you put paper in the paper tray, first empty the tray of any other
paper then put the printed page in to the empty tray, with the printed side face up. (Do not add printed
pages to the top of a stack of unprinted paper.)
(For manual duplex printing )
For thick paper that has curled once the first side has been printed on, you cannot feed the paper
for the second time from the MP tray to allow the other side of the paper to be printed.
At the back of the printer, open the back output tray and push down the two blue tabs one on the
left and one on the right hand side (as shown in Figure 1-51). When you have finished printing, close
the back output tray to reset the two blue tabs back to their original position.
Figure 1-51