Brother HL-6050DN - Manual (Page 41)

1 - 33 ABOUT THIS PRINTER
5
Put transparencies in the MP tray. Put the side to be printed on first, face up, with the leading edge
(top) of the paper in first. Make sure the transparencies touch the back of the tray and remain under
the maximum paper height guides on both sides of the tray. Do not put more than 10 transparencies
in the MP tray at any one time, or it may cause a jam.
Figure 1-43
6
While pressing the paper guide release lever, slide the paper guide to fit the transparency size.
Figure 1-44
Make sure that the transparencies are straight and in the proper position in the MP tray. If they are
not, the transparencies may not be fed properly, resulting in a skewed printout or a jam.
When you put transparencies in the MP tray, please remember the following:
■ The side to be printed on must be face up.
■ Put the leading edge (top of the transparencies) in first and push it gently into the tray.
■ The top of the transparency stack must be under the maximum paper height guides that are on
both sides of the tray.