Brother HL-6050DN - Manual (Page 27)

1 - 19 ABOUT THIS PRINTER
5
Put paper in the MP tray. Put the side to be printed on first, face up, with the leading edge (top) of
the paper in first. Make sure the paper touches the back of the tray and remains under the maximum
paper height guides on both sides of the tray.
Figure 1-23
6
While pressing the paper-guide release lever, slide the paper guide to fit the paper size.
Figure 1-24
7
Send the print data to the printer.
8
After you finish the print job, close the back output tray.
Make sure that the paper is straight and in the proper position in the MP tray. If it is not, the paper
may not be fed properly, resulting in a skewed printout or a paper jam.
When you put paper in the MP tray, please remember the following:
■ During printing, the inside tray rises to feed paper into the printer.
■ The side to be printed on must be face up.
■ Put the leading edge (top of the paper) in first and push it gently into the tray.
■ The top of the paper stack must be under the maximum paper height guides that are on both
sides of the tray.