FUTEK IPM500 (D500) Digital Display - Manual (Page 28)

28
Option board dependent menu items
ALSEt . ALS34 dEU1H dEU2H dEU1b dEU2b dEU3H DEU4H DEU3b DEU4b
Menu items related to alarm setup These will only appear if a relay board is detected. If so,
please see Section16.
AnSEt . An Lo . An Hi ..
Menu items related to analog output setup. These will only appear if an analog output
board is detected. If so, see Section 17.
SEr 1 . SEr 2 . SEr 3 . SEr 4 . _ Addr
Menu items related to serial communications. These will only appear if an RS232 or
RS485 I/O board is detected. If so, see Section 18.
Menu lockout items
Loc 1 . Loc 2 . Loc 3 .
Menu items used to enable or lock out (hide) other menu items. Loc menu items may in turn
be locked out by a hardware jumper. Please see Section 9.
* Scaling method 2, “Reading Coordinates of 2 Points Scaling Method,” will appear before all
other Menu items, including _ InPut . Decimal point is set by dEC.Pt
.