FUTEK IPM500 (D500) Digital Display - Manual (Page 2)

2
1. TABLE OF CONTENTS
1. TABLE OF CONTENTS............................................................................................... 2
2. TEDS INTRODUCTION............................................................................................... 2
3. IPM490 / IPM500 INTRODUCTION............................................................................. 3
4. RECEIVING & UNPACKING ....................................................................................... 4
5. SAFETY CONSIDERATIONS...................................................................................... 4
6. CONNECTOR WIRING INFORMATION ..................................................................... 5
7. MECHANICAL ASSEMBLY ......................................................................................... 7
8. FRONT PANEL SETUP KEYS .................................................................................... 9
9. ENABLING & LOCKING OUT MENU ITEMS .............................................................. 11
10. READING COORDINATES OF 2 POINTS SCALING METHOD ................................. 12
11. DC VOLTS, AMPS, PROCESS, STRAIN INPUT......................................................... 13
12. LOAD CELL & MICROVOLT INPUT............................................................................ 18
13. AC RMS VOLTS & AMPS INPUT ................................................................................ 23
14. THERMOCOUPLE INPUT........................................................................................... 29
15.
RTD & RESISTANCE INPUT ...................................................................................... 32
16. DUAL & QUAD RELAY OUTPUT OPTIONS .............................................................. 37
17. ANALOG OUTPUT OPTION ....................................................................................... 40
18. SERIAL COMMUNICATION OPTIONS ....................................................................... 41
19. TEDS INTERFACE ...................................................................................................... 44
20. EXCITATION OUTPUT & POWER SUPPLY............................................................... 46
21. METER CALIBRATION ............................................................................................... 47
22. SPECIFICATIONS ....................................................................................................... 50
23. GLOSSARY
OF TERMS.............................................................................................. 54
2. TEDS INTRODUCTION
TEDS, or Transducer Electronic Data Sheet, is based on the IEEE 1451.4 standard. TEDS
enabled sensors contain an EEPROM that stores sensor information such as serial number,
calibration dates, and calibration factors. An IPM500 display with a TEDS reader will automa-
tically retrieve this information once a TEDS enabled sensor is plugged into the system. This
greatly simplifies calibration and configuration of the sensor. Please see Section 19 for setup.