FUTEK IPM500 (D500) Digital Display - Manual (Page 10)

10
KEYS IN MENU MODE
Right Arrow Key (MENU).
Pressing steps the meter through all menu items that
have been enabled and then back to the Run Mode. With the DC signal conditioner
board and no option boards, available menu items are _
InPut , SEtuP , ConFG , _ FiLtr ,
dEc.Pt
,
SCALE
,
OFFst
,
Loc 1
,
Loc 2
,
Loc 3
. If a change has been made to a menu
item, that change is saved to non-volatile memory when the key is pressed next,
and
StoreE
is displayed briefly.
Right Triangle Key (Digit Select).
• Pressing from the InPut menu brings up all meter functions available with the
meter's signal conditioner. For the DC signal conditioner, these are _ dC U , _ dC A
and _
rAtio
.
• Pressing from the SEtuP, ConfFG, FiLtr, SCALE, OFFSt, Loc 1, Loc 2 or Loc 3
menus items sequentially selects digit positions 1 - 5, as indicated by a flashing digit:
0
0000 , 00000 , 00000 , 00000 , 00000 .
• Pressing from the dEC.Pt menu item sequentially selects decimal point positions,
which will flash: d .dddd dd.ddd ddd.dd dddd.d ddddd. .ddddd .
Up Triangle Key (Value Select).
Pressing for a flashing item (digit position or
decimal point position) will increment that item. Pressing MENU will save any changes.
Left Arrow Key (Reverse Menu).
Pressing has the same effect as the MENU key,
except that menu items are brought up in reverse order.