Dwyer 32DZ - Manual (Page 34)

949-1318 Page 34 of 40 June, 2000
The following Menu Items operate on the entire Instrument.
There is no Set Point distinction. These items will appear in
both the
Edit1 Edit1 Edit1 Edit1 Edit1 , Edit2 Edit2 Edit2 Edit2 Edit2 , and Edit3 Edit3 Edit3 Edit3 Edit3 menus.
SP1o SP1o SP1o SP1o SP1o Set Point 1 Output Select: Select OutA OutA OutA OutA OutA or Outb Outb Outb Outb Outb .
OutA OutA OutA OutA OutA Set Point 1 is routed through Output A, Set Point 2 is
routed through Output B.
Outb Outb Outb Outb Outb Set Point 1 is routed through Output B, Set Point 2 is
routed through Output A.
COPY COPY COPY COPY COPY Copy Zone Parameters. Copies program parameters from one
zone to the other.
none none none none none No copy function is performed. Factory default.
1to2 1to2 1to2 1to2 1to2 Copies all parameters from Zone 1 to Zone 2.
2to1 2to1 2to1 2to1 2to1 Copies all parameters from Zone 2 to Zone 1.
Addr Addr Addr Addr Addr (Option 992, Serial Communications) Control Address: Select
from
1 11 11 to 3FE 3FE 3FE 3FE 3FE . This number (hexadecimal, base 16) must match
the address number used by the host computer. The value
displayed is for Zone 1. The address for Zone 2 is the value
for Zone 1 plus one (e.g. if
Addr is set to 17 , Zone 1 is
assigned to address 17 and Zone 2 is assigned to address
18 ). Addresses 100 , 200 , and 300 are reserved for Factory
use.
bAUd bAUd bAUd bAUd bAUd (Option 992, Serial Communications) Communication Baud
Rate: Select
300 300 300 300 300 , 1200 1200 1200 1200 1200 , 2400 2400 2400 2400 2400 , 4800 4800 4800 4800 4800 , 9600 9600 9600 9600 9600 , or 192 192 192 192 192 00. This
number must match the baud rate used by the host computer.
nAt nAt nAt nAt nAt (Option 992, Serial Communications) No Activity Timer:
Set from
OFF OFF OFF OFF OFF or 1 11 11 to 99 99 99 99 99 minutes.
1 11 11 - 99 99 99 99 99 Maximum time between host computer accesses.
If timer counts to 0,
CHEC LorE will be displayed.
OFF OFF OFF OFF OFF No Activity Timer function is disabled.