Dwyer 32DZ - Manual (Page 14)

949-1318 Page 14 of 40 June, 2000
FACTORY DEFAULT PROCEDURE
If for any reason you wish to restore the factory settings use the following
procedure.
1.
Turn off power to control
2. Turn on power to control
3. While control is performing SELF SELF SELF SELF SELF tESt tESt tESt tESt tESt , press and hold the
INDEX
and ENTER keys.
4. The control will display the ROM ID code. Press
INDEX.
5. The control will display FACt FACt FACt FACt FACt dFLt dFLt dFLt dFLt dFLt . If you wish to just restore factory
settings, Press
ENTER and DOWN ARROW at the same
time. The control will be reset to the original factory settings.
6. Press
INDEX to display
OPt OPt OPt OPt OPt . If your control is equipped with an
option, press the UP ARROW to display the option number. If the
number is flashing, press
ENTER. An enabled option does not
flash.
7. Press
INDEX to display
ACPt ACPt ACPt ACPt ACPt . Select YES YES YES YES YES or no no no no no .
YES YES YES YES YES Changes are accepted and control re-boots.
no no no no no Changes are discarded and control re-boots.
8. Press
ENTER.
The control will re-initialize with Factory Default settings.
THE BAUD RATE AND ADDRESS MENU ITEMS WILL TAKE EFFECT ON THE
NEXT POWER UP OF THE CONTROL. BE SURE TO POWER CYCLE THE
CONTROL BEFORE USING THE NEW BAUD RATE AND ADDRESS.
In operation, you have the option of preventing a write command from the host
computer. To prevent the host from writing to the control change the
LOrE LOrE LOrE LOrE LOrE menu
item in the Secondary Menu to LOC LOC LOC LOC LOC . To allow the host to write commands to
the control set LOrE LOrE LOrE LOrE LOrE to rE rE rE rE rE . (The host does have the ability to change the LOrE LOrE LOrE LOrE LOrE
state, but it is not automatic.)
If your system depends on constant reading or writing to and from the host, you
may wish to set the No Activity Timer (
nAt nAt nAt nAt nAt ) to monitor the addressing of the
control. When the LOrE LOrE LOrE LOrE LOrE is set to rE rE rE rE rE and the nAt nAt nAt nAt nAt is set to any value other than
Off , the control will expect to be addressed on a regular basis. If the control
is not addressed in the time set by the value of nAt nAt nAt nAt nAt , then the control will display
the error message CHEC LOrE CHEC LOrE CHEC LOrE CHEC LOrE CHEC LOrE . To clear the message set LOrE LOrE LOrE LOrE LOrE to LOC LOC LOC LOC LOC .