Dwyer 32DZ - Manual (Page 16)

949-1318 Page 16 of 40 June, 2000
Power On, PEA2 is reset to the present input. To manually
reset the value PEA2 PEA2 PEA2 PEA2 PEA2 must be in the lower display. Press
the ENTER key to reset. PEA2 PEA2 PEA2 PEA2 PEA2 will be reset and display the
present input value.
UAL2 UAL2 UAL2 UAL2 UAL2 The Valley feature stores the lowest input the Instrument
has measured for Zone 2 since the last reset or Power On.
At Power On,
UAL2 UAL2 UAL2 UAL2 UAL2 is reset to the present input. To manually
reset the value UAL2 UAL2 UAL2 UAL2 UAL2 must be in the lower display. Press
the ENTER key. UAL2 UAL2 UAL2 UAL2 UAL2 will be reset and display the present
input value.
LOrE LOrE LOrE LOrE LOrE (Option 992, Serial Communications) Local / Remote Sta-
tus: Select
LOC LOC LOC LOC LOC or rE rE rE rE rE .
LOC LOC LOC LOC LOC The host computer is advised not to send remote
commands. Any write commands sent to the
controls will be rejected.
rE rE rE rE rE The host computer is allowed to send write
commands.If the control is not addressed within
the time set in the
nAt nAt nAt nAt nAt (No Activity Timer, see
Secure Menu) the CHEC LorE CHEC LorE CHEC LorE CHEC LorE CHEC LorE error message will be
displayed.
Addr Addr Addr Addr Addr (Option 992, Serial Communications) Control Address: Set
from
1 to 3FF . This number (hexadecimal, base 16) must
match the address number used by the host computer.
Viewed only in this menu. The value displayed is for Zone
1. The address for Zone 2 is the value for Zone 1 plus one.
To change this parameter, see
Addr Addr Addr Addr Addr in the Secure Menu.
End of Secondary Menu when Edit Edit Edit Edit Edit is set to 0 00 00 .