Dwyer 32DZ - Manual (Page 26)

949-1318 Page 26 of 40 June, 2000
If Edit Edit Edit Edit Edit is set to 1 11 11 or 3 33 33 , begin.
If Edit Edit Edit Edit Edit is set to 2 22 22 , jump to SEC2 SEC2 SEC2 SEC2 SEC2 on page 30.
SEC1 SEC1 SEC1 SEC1 SEC1 Security Code: See the Security Level Selection and the
Password Table in this manual, in order to enter the correct
password.
InP1 InP1 InP1 InP1 InP1 Input Type: Select one of the following. Refer to the Input
wiring section for the proper wiring.
J-IC J-IC J-IC J-IC J-IC Type “J” Thermocouple
CA CA CA CA CA Type “K” Thermocouple
E- E- E- E- E- Type “E” Thermocouple
L- L- L- L- L- Type “L” Thermocouple
n- n- n- n- n- Type “N” Thermocouple
t- t- t- t- t- Type “T” Thermocouple
r-13 r-13 r-13 r-13 r-13 Type “R” Thermocouple
S-10 S-10 S-10 S-10 S-10 Type “S” Thermocouple
b- b- b- b- b- Type “B” Thermocouple
C- C- C- C- C- Type “C” Thermocouple
P392 P392 P392 P392 P392 100 ohm Platinum (NIST 0.00392
Ω/Ω
/°C)
n120 n120 n120 n120 n120 120 ohm Nickel
P385 P385 P385 P385 P385 100 ohm Platinum (DIN 0.00385
Ω/Ω
/°C)
1P38 1P38 1P38 1P38 1P38 1000 ohm Platinum (DIN 0.00385
Ω/Ω
/°C)
Curr Curr Curr Curr Curr DC Current Input 0.0 to 20.0 or 4.0 to 20.0 mA.
UoLt UoLt UoLt UoLt UoLt DC Voltage Input 0.0 to 10.0 or 2.0 to 10.0 volts.
diFF diFF diFF diFF diFF DC Voltage Input -10 to +10 mV.
---- ---- ---- ---- ---- Reserved
Caution: Do not change the Input Type outside of the
programming Group on the Model Number. The input
will not function correctly if the Input Type is set to a
selection outside the specified Input Group.
0SP1 0SP1 0SP1 0SP1 0SP1 Zero Suppression: Select On On On On On or OFF OFF OFF OFF OFF . Only with Current and
Voltage input types.
OFF OFF OFF OFF OFF The input range will start at 0 (zero) Input.
On On On On On The input range will start at 4.00 mA or 2.00 V.
Unt1 Unt1 Unt1 Unt1 Unt1 F FF FF , C CC CC or None None None None None .
F FF FF °F lamp is On and temperature inputs will be
displayed in degrees Fahrenheit.
C CC CC °C lamp is On and temperature inputs will be
displayed in degrees Celsius.
nonE nonE nonE nonE nonE Both the°F and °C lamps will be Off. This selection
is only available with Current and Voltage Inputs.
Input Group 4
Input Group 1
Input Group 2
Input Group 3
Input Group 6
Input Group 5