Dwyer 32DZ - Manual (Page 24)

949-1318 Page 24 of 40 June, 2000
InC2 InC2 InC2 InC2 InC2 Input Correction: Select -500 -500 -500 -500 -500 to 500 °F, °C, or counts. This
feature allows the input value to be changed to agree with
an external reference or to compensate for sensor error.
Note:
InC2 is reset to zero when the input type is changed,
or when decimal position is changed.
Fil2 Fil2 Fil2 Fil2 Fil2 Digital Filter: Select OFF OFF OFF OFF OFF , 1 11 11 to 99 99 99 99 99 . In some cases the time
constant of the sensor, or noise could cause the display to
jump enough to be unreadable. A setting of
2 is usually
sufficient to provide enough filtering for most cases, ( 2
represents approximately a 1 second time constant). When
the 0.1 degree resolution is selected this should be in-
creased to
4 . If this value is set too high, controllability will
suffer.
LPb2 LPb2 LPb2 LPb2 LPb2 Loop Break Protection: Select OFF OFF OFF OFF OFF , 1 11 11 to 9999 9999 9999 9999 9999 seconds. If,
during operation, the output is minimum (0%) or maximum
(100%), and the input moves less than 5°F (3°C) or 5 counts
over the time set for Lpb2, the
LOOP bAd LOOP bAd LOOP bAd LOOP bAd LOOP bAd message will
appear. The loop break error can be reset by pressing the
ENTER key when at the
LPb2 menu item. The INDEX &
ENTER keys may also be used.
The following Menu Items operate on the entire instrument.
There is no Zone or Set Point distinction. They will appear in
the
Edit1 Edit1 Edit1 Edit1 Edit1 , Edit2 Edit2 Edit2 Edit2 Edit2 , and Edit3 Edit3 Edit3 Edit3 Edit3 menus.
LOrE LOrE LOrE LOrE LOrE (Option 992, Serial Communications) Local / Remote Sta-
tus: Select
LOC LOC LOC LOC LOC or rE rE rE rE rE .
LOC LOC LOC LOC LOC The host computer is advised not to send remote
commands. Any write commands sent to the
controls will be rejected.
rE rE rE rE rE The host computer is allowed to send write
commands.If the control is not addressed within
the time set in the
nAt nAt nAt nAt nAt (No Activity Timer, see
Secure Menu) the CHEC LorE CHEC LorE CHEC LorE CHEC LorE CHEC LorE error message will
be displayed.
Addr Addr Addr Addr Addr (Option 992, Serial Communications) Control Address:
Read value from
1 11 11 to 3FF 3FF 3FF 3FF 3FF . This number (hexadecimal, base
16) must match the address number used by the host
computer. Viewed only in this menu. The value displayed
is for Zone 1. The address for Zone 2 is the value for Zone
1 plus one (e.g. if
Addr Addr Addr Addr Addr is set to 17 17 17 17 17 , Zone 1 is assigned to