Thermo Fisher Scientific CyberScan DO 110 - Manual (Page 24)

Instruction Manual CyberScan DO 110
19
To Print Selected Stored Data:
1. From measurement mode, press MR/▼ key.
2. “MEM” indicator appears and the last memory input location is displayed.
3. Press MI/▲ or MR/▼ key to select a specific memory location, and press
HOLD/ENTER key.
4. When ready, press PRINT key.
5. The screen flashes “Prn/CUr” for about 0.5 seconds and switches back to the
stored data of the specific memory location.
6. Press HOLD/ENTER key. The meter is now ready to recall the next stored
data in the following memory location. See Figure 13.
ATC
°C
mg/l
mg/l
mg/l
8.10
24.5
MEAS
READY
During measurement mode
Repeat print procedure or
press CAL to exit
For example,select
memory location 10
Last memory input
location
Moves to next
memory location
MR
MEM
MEM
MEM
loc
loc
loc
20
10
9
MEM
MEM
5.69
5.69
22.4
22.4
ENTER
HOLD
ENTER
HOLD
ATC
°C
ATC
°C
MI MR
Flash for 0.5 seconds
Figure 13: Print based on selected stored data from memory
For more information about Eutech Instruments’ CyberComm Portable Data
Acquisition Software programme, see section 9 - CYBERCOMM PORTABLE DAS
on page 34.