Thermo Fisher Scientific CyberScan DO 110 - Manual (Page 22)

Instruction Manual CyberScan DO 110
17
7.2.1 Print Current Data Manually
To manually print any data that is currently being measured:
1. From measurement mode, press HOLD key to freeze
reading. See Figure 10.
2. Print PRINT ( ) key.
3. The “Prn – CUr” annunciator will appear and flash for
about 0.5 seconds. The data is transmitted to the printer
or computer.
4. The meter returns to measurement mode.
5. Repeat steps 1 to 3 for next measurement.
7.2.2 Print Data on Timed Interval
This feature is useful to automate printing and downloading ‘live’ measurement
values into computer. The time interval setting can range from
5 to 30 seconds.
1. From the measurement mode, press PRINT key.
2. Select “Dat/Cur” screen and press HOLD/ENTER key.
3. The “Sec 5” screen appears. The default value is 5
seconds time interval.
4. Press MI/▲ or MR/▼ key to set a value suitable for your
application.
5. Press HOLD/ENTER key.
6. The meter goes into measurement mode with MEM
annunciator flashing.
7. At a pre-set time interval, the screen flashes “Prn/CUr”
momentarily (printing data) and switches back to
measurement mode with MEM annunciator flashing.
8. To stop printing, press PRINT key. The MEM
annunciator disappears and the meter is on measurement mode.
Figure 10: Print current data
manually
Flash for 0.5 seconds
MEAS
ATC
°C
mg/l
8.10
24.5
READY
HOLD
MEAS
ATC
°C
mg/l
8.10
24.5
READY
5
10
sec
sec
ENTER
HOLD
MI MR
Figure 11: Print data on timed
interval