Techne PrimeG - Manual (Page 25)

24
Advanced temperature entry
• First ensure the number of cycles for the stage has been set then enter the required hold
temperature as described above.
Note: Increase/Decrease Per Cycle will be inactive unless the number of cycles set is greater than 1.
To increase the step temperature per cycle:
• For an increase in temperature per cycle, touch
the button below Increase Per Cycle to turn this
function on. Next touch the temperature entry
button below this.
A new screen will open which is similar to the simple
temperature entry screen. The maximum increase in
temperature per cycle (based on the number of cycles
and the temperature limits of the unit) will be shown.
• Enter the required value.
• Touch DEL to clear the entry.
• If an entered incremented temperature is invalid, a
prompt will indicate the acceptable range.
• Touch OK to accept and return to the previous
screen.
The increase in temperature per cycle will now be
displayed.
• Touch OK again to return to the programming
screen.
• Touch Cancel to return to the programming screen
if no changes are required.