Techne PrimeG - Manual (Page 19)

18
INSTALLATION
See also the Safety Information sections on pages 5 to 14.
Front view
1. Lid adjustment knob.
2. Lid release latch.
3. 5.7” colour VGA LCD touch screen display.
4. USB port for memory stick.
Rear view
1. Mains cable inlet.
2. On/Off rocker switch
3. USB port for service and calibration only.
Installation
1. Place the unit on a suitable flat bench, ensuring that the air inlet vents on the sides are free from
obstruction.
2. Note that block removal can only be performed by a qualified service engineer.
3. Note that when using the Combi-Block, only tubes of one type should be used, either 0.2ml or
0.5ml.
4. Plug the mains cable into the socket on the back of the instrument.
5. Connect to the mains electricity supply with the plug provided or one wired correctly for the
supply. Switch the power ON using the switch located on the rear of the unit. The front display will
then light up.