Revo R16/8/4/DVR - Manual (Page 43)

Digital Video Recorder
37
y From: Pressing the
button toggles between On and Off. When set to Off, you can enter a specific Date and Time.
When set to On, the search will be from the first recorded image.
y To: Pressing the
button to toggles between On and Off. When set to Off, you can enter a specific Date and Time.
When set to On, the search will be to the last recorded image.
y Type: Select between Motion Search and Museum Search. Motion Search detects motion in the defined area.
Museum Search detects if a defined object has moved.
y Zone: Press the
button, and an image from the video appears with a grid overlay. You can turn sensor blocks
On and Off to define the area of the picture in which you want to search for motion. The zone should be placed or
focused on the centre or, at least, within the outline of targeted object.
NOTE: Defining the area of the image in which you want to search for motion is nearly identical to setting up
the DVR for Motion Detection. Please refer to the Motion Event Settings section in Chapter 2 — Installation
& Configuration – Main Setup, Event Setup for more detailed instructions on setting up the detection blocks.
NOTE: When setting the Museum Search Zone, the zone should be placed inside of the border line of the target
object. If the selected block is placed on the boarder line, the sensitivity of the Museum Search may decrease.
y Sensitivity: Select the sensitivity from 1 (low sensitivity) to 5 (high sensitivity).
y Min. Blocks: Set the number of sensor blocks that must be activated. Setting the Min Blocks will only be available
if Motion Search is selected in the Type field.
Once you set your desired search conditions, select Search and press the
button to display the search results in the
Motion Search screen. Selecting Cancel exits the screen without saving the changes.
When you search for motion events for another camera, you will be asked whether or not you want to delete the previous
search results from the list.
GO TO
Go to the First
Selecting Go to the First displays the first recorded image.
Go to the Last
Selecting Go to the Last displays the last recorded image.
Go to the Date/Time
You can use the Left and Right arrow buttons on the remote control to select the year,
month, day, hours, minutes and seconds. Use the Up and Down arrow buttons to change
to the date and time you want to search for video. Once you have set the date and time,
press the
button. Then select Go and press the button to display the image recorded
at the selected time. The Playback buttons on the remote control can now be used to review
the surrounding video. (If no video was recorded during the selected time, a message
appears alerting you that no image was recorded at that time.)