Revo R16/8/4/DVR - Manual (Page 14)

User’s Manual
8
INFRARED REMOTE CONTROL
ID
DISPLAY
SEQUENCE
FREEZE
ALARM
CAMERA
PTZ Control (FOCUS, PRESET, ZOOM)
MENU
PTZ Mode
Arrows
Enter
ZOOM Mode
PLAYBACK
(Stop, Pause, Play, RW, FF, Next, Previous)
ID Button
If a DVR System ID is set to 0, the infrared remote control will control that DVR without any additional entries. (Refer
to the Main Setup section in this chapter for further information on setting the System ID.) If the DVR system ID is 1 to 16,
you must to press the ID button on the remote control followed by the number button (1 to 16) in order to control that
DVR. If two or more DVRs have the same ID, those DVRs will react to the infrared remote control at the same time.
CAMERA Buttons (1 to 16)
Pressing the individual camera buttons will cause the selected camera to display full screen. Buttons 1 to 9 are also
used to enter passwords.
DISPLAY Button
Pressing the DISPLAY button toggles between different display formats. The available formats are: full, 4x4, 3x3,
2x2 and PIP.
When the DVR does not detect a VGA monitor automatically, pressing and holding the button for 5 seconds or longer
will toggle the video output between the composite video output and VGA out. During clip copy, you cannot switch
the video output mode.