KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 62)

4
OPERATION
62
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
Subcode R An enumeration specifying the cause of the alert to be
reported.
Other
Setting:
• Other: Non-specific error active
• BlockConfiguration: Error detected in block configuration
• LinkConfiguration: Error detected in link configuration
• SimulationActive: Simulation enabled in this block
• LocalOverride: Output tracking or faultstate active
• DeviceFaultState: DeviceFaultState
• DeviceMaintenance: Device needs maintenance soon
• InputFailure: Process variable has bad status
• OutputFailure: Failure detected in output hardware
• MemoryFailure: Memory error detected
• LostStaticData: Static parameters cannot be recovered
• LostNVData: Non-Volatile parameters cannot be recovered
• ReadbackCheck: Failure detected in READBACK
• MaintenanceNeeded: Device NEEDS maintenance NOW
• PowerUp: Recovery from power failure
• OutOfService: Block actual mode is Out of Service
Value R The value of the associated parameter at the time the alert
was detected.
0
Setting:
0...255
BYPASS BYPASS BYPASS BYPASS
Bypass Bypass Bypass Bypass
R/W The normal control algorithm may be bypassed through this
parameter. When bypass is set, the setpoint value (in percent)
will be directly transferred to the output. To prevent a bump
on transfer to/from bypass, the setpoint will automatically be
initialized to the output value or process variable, respectively,
and the path broken flag will be set for one execution.
Uninitialized
Setting:
• ON: normal control algorithm bypassed, output based on
setpoint
• OFF: normal control
CAS_IN CAS_IN CAS_IN CAS_IN
Cascade Input Cascade Input Cascade Input Cascade Input
R/W This parameter is the remote setpoint value, which must
come from another Fieldbus block or a DCS block through a
defined link.
-
Status R/W Status of CAS_IN -
Value R/W Value of CAS_IN -
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value