KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 31)

OPERATION
4
31
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
FD_RECOMMEN_ACT FD_RECOMMEN_ACT FD_RECOMMEN_ACT FD_RECOMMEN_ACT
Recommended Action Recommended Action Recommended Action Recommended Action
R This parameter is a device enumerated summarization of the
most severe condition or conditions detected. The DD help
should describe by enumerated action, what should be done to
alleviate the condition or conditions.
Uninitialized
Setting:
• Uninitialized
• The device operates satisfactorily. No action is required.
• The "Simulate" jumper is installed. Remove the jumper to
go back to normal operation.
• The Transducer Block into AUTO mode. Set Transducer
Block into AUTO mode.
• Make sure that the HART Slave operates satisfactorily
• Contact the supplier
• Replace the electronics module or contact the supplier
• Check the power supply at the device terminals. If the
voltage is correct, contact the supplier.
• Measure the voltage at the device terminals. Make sure that
the internal cable is connected between the front end and
the back end. For remote configuration, make sure that that
the electrical wires are connected to the terminals. If
necessary, contact the supplier.
• Temperature is above +85°C / +185°F or below -45°C / -
49°F. Process temperature or ambient temperature is
above the maximum limit or below the minimum limit.
Action: Measure the device temperature.
• Firmware incompatibility. Contact the supplier.
• Replace the electronics module or contact the supplier
• Measure the level signal amplitude of the device. Configure
the device. If necessary, contact the supplier.
• The level signal is in the blocking distance. Action: Lower
the level until it is below the blocking distance.
• Make sure that the antenna is attached to the process
connection. If necessary, contact the supplier.
• Recommended action for Condition 18
• Recommended action for Condition 19
• Recommended action for Condition 20
• Recommended action for Condition 21
• The electronics block is near to its minimum or maximum
operating temperature. Action: Measure the device
temperature.
• Measure the level signal amplitude of the device. Configure
the device. If necessary, contact the supplier.
• The level signal is in the blocking distance. Action: Lower
the level until it is below the blocking distance.
• Recommended action for Condition 27
• Recommended action for Condition 28
• Recommended action for Condition 29
• The device is in configuration mode after a user used the
local display to enter a menu. Action: Use the local display
to go back to normal mode.
• Unknown Alarm Event appeared
FD_SIMULATE FD_SIMULATE FD_SIMULATE FD_SIMULATE
Field Diagnostic Field Diagnostic Field Diagnostic Field Diagnostic
Simulate Simulate Simulate Simulate
Used as the field diagnostic condition when the simulation is
enabled.
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value