KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 58)

4
OPERATION
58
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
PULSE_ERROR
Hardware error
R Hardware error
Setting:
Peak Lost (Level Lost) Error / Overfill Error / not defined
WARNING_MAINTENANCE
Warning (Maintenance
required)
R Warning (Maintenance required)
Setting:
Peak Lost (Level Lost) Warning / Overfill Warning / Empty
Spectrum Invalid / Signal Weak / Signal Strong / No
Measurement / not defined
WARNING_OUT_OF_SPEC
Warning (Out of
Specifications)
R Warning (Out of Specifications)
INFORMATIONAL
Information
R Information
Setting:
First Start / Spectrum Quality Bad / Peak Lost in Tank
Bottom / Outside Temperature Operating Range of HMI / not
defined
TRANSDUCER_DIRECTORY TRANSDUCER_DIRECTORY TRANSDUCER_DIRECTORY TRANSDUCER_DIRECTORY
Transducer Directory Entry Transducer Directory Entry Transducer Directory Entry Transducer Directory Entry
R A directory that specifies the number and starting indices of
the data collections in the Transducer Block.
TRANSDUCER_TYPE TRANSDUCER_TYPE TRANSDUCER_TYPE TRANSDUCER_TYPE
Transducer Type Transducer Type Transducer Type Transducer Type
R Identifies the transducer that follows. Other
XD_ERROR XD_ERROR XD_ERROR XD_ERROR
Transducer Error Transducer Error Transducer Error Transducer Error
R One of the transducer error codes defined in section 4.7
"Block Alarm Subcodes" of the FF Transducer Specifications.
Uninitialized
Setting:
Unspecified error / General error / Calibration error /
Configuration error / Electronics Failure / Mechanical
Failure / I/O Failure / Data Integrity Error / Software Error /
Algorithm Error
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value