KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 39)

OPERATION
4
39
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
LOW_CUT LOW_CUT LOW_CUT LOW_CUT
Low Cutoff Low Cutoff Low Cutoff Low Cutoff
RW Limit used in square root processing. A value of zero percent of
scale is used in block processing if the transducer value falls
below this limit, in %of scale. This feature may be used to
eliminate noise near zero for a flow sensor.
0.0
Setting:
≥0.0
OUT OUT OUT OUT
Output Output Output Output
RW The primary analogue discrete value calculated as a result of
executing the function.
STATUS
Status
R Digital transducers, unlike their analogue versions, can detect
faults that make the measurement bad or prevent the actuator
from responding. This additional, valuable information will be
passed along with each transmission of a data value in the
form of a status attribute.
VALUE
Value
RW A numerical quantity entered by a user or calculated by the
algorithm.
0.0
OUT_SCALE OUT_SCALE OUT_SCALE OUT_SCALE
Output Scale Output Scale Output Scale Output Scale
RW The high and low scale values, engineering units code and
number of digits to the right of the decimal point to be used in
displaying the OUT parameter and parameters which have the
same scaling as OUT.
EU_100
EU at 100%
RW The engineering unit value which represents the upper end of
range of the associated block parameter.
100.0
EU_0
EU at 0%
RW The engineering unit value which represents the lower end of
range of the associated block parameter.
0.0
UNITS_INDEX
Units Index
RW Device Description units code index for the engineering unit
descriptor for the associated block value.
Uninitialized
Setting:
All units are possible.
DECIMAL
Decimal
RW The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
PV PV PV PV
Process Value Process Value Process Value Process Value
Either the primary analog value for use in executing the
function, or a process value associated with it. May also be
calculated from the RBACK value of an AO block.
-
STATUS
Status
R Digital transducers, unlike their analogue versions, can detect
faults that make the measurement bad or prevent the actuator
from responding. This additional, valuable information will be
passed along with each transmission of a data value in the
form of a status attribute.
0
VALUE
Value
R A numerical quantity entered by a user or calculated by the
algorithm.
0.0
PV_FTIME PV_FTIME PV_FTIME PV_FTIME
Process Value Filter Process Value Filter Process Value Filter Process Value Filter
Time Time Time Time
RW Time constant of a single exponential filter for the PV, in
seconds.
0.0
Setting:
0.0…60.0
SIMULATE SIMULATE SIMULATE SIMULATE
Simulate Simulate Simulate Simulate
Allows the transducer analog input or output to the block to be
manually supplied when simulate is enabled. When simulate is
disabled, the simulate value and status track the actual value
and status.
SIMUULATE_STATUS
Simulate Status
RW Used for the transducer status when simulation is enabled. 0
SIMULATE_VALUE
Simulate Value
RW Used for the transducer value when simulation is enabled. 0.0
Setting:
-3.39E38…+3.39E38 / -INF (-infinite) / + INF (+infinite)
TRANSDUCER_STATU
S
Transducer Status
R Status of value supplied by transducer. 0
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value