KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 25)

OPERATION
4
25
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
FD_FAIL_MASK FD_FAIL_MASK FD_FAIL_MASK FD_FAIL_MASK
Fail Mask Fail Mask Fail Mask Fail Mask
RW This parameter allows the user to suppress any single or
multiple conditions that are active, in this category, from
being broadcast to the host through the alarm parameter.
(0)-(31) masked
Setting:
• (00) Check Function
• (01) Cond01
• (02) Cond02
• (03) Cond03
• (04) Cond04
• (05) Cond05
• (06) Cond06 disabled
• (07) Bad Measurement quality disabled
• (08) Signal Strong disabled
• (09) Signal Weak disabled
• (10) Empty Spectrum invalid disabled
• (11) Sensor No Signal
• (12) Sensor Microwave Error disabled
• (13) Temperature Above +75°C disabled
• (14) Temperature Below -35°C disabled
• (15) Overfill Warning disabled
• (16) Level Lost warning disabled
• (17) Temperature out of range (warning) disabled
• (18) Local operation disabled
• (19) Overfill Error disabled
• (20) Level lost error disabled
• (21) Temperature out of range Error disabled
• (22) Converter Voltage Error disabled
• (23) Converter ROM Error disabled
• (24) Converter RAM Error disabled
• (25) Converter EEPROM Error disabled
• (26) Sensor not compatible disabled
• (27) Internal Communication Error disabled
• (28) Sensor Voltage Error disabled
• (29) Sensor ROM Error disabled
• (30) Sensor RAM Error disabled
• (31) Sensor EEPROM Error disabled
FD_FAIL_PRI FD_FAIL_PRI FD_FAIL_PRI FD_FAIL_PRI
Fail Priority Fail Priority Fail Priority Fail Priority
RW This parameter allows the user to specify the priority of this
alarm category.
0
Setting:
0...15
FD_MAINT_ACTIVE FD_MAINT_ACTIVE FD_MAINT_ACTIVE FD_MAINT_ACTIVE
Maintenance Active Maintenance Active Maintenance Active Maintenance Active
R This parameter reflects the error conditions that are being
detected as active as selected for the "Maintenance" category.
It is a bit string, so that multiple conditions may be shown.
FD_MAINT_ALM FD_MAINT_ALM FD_MAINT_ALM FD_MAINT_ALM
Fail Maintenance Fail Maintenance Fail Maintenance Fail Maintenance
Alarm Alarm Alarm Alarm
This parameter is used primarily to broadcast a change in the
associated active conditions, which are not masked, for this
alarm category to a Host System.
UNACKNOWLEDGED
Unacknowledged
RW A discrete enumeration which is set to "Unacknowledged"
when an alarm occurs, and set to "Acknowledged" by a write
from a human interface device or other entity which can
acknowledge that the alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value